stj
Great Sage 齊天大聖
Last Activity: Today, 06:05 PM
Joined: 12-23-2009
Location: Europe
-
film caps are the way to go.... -
the caps wont dry out or leak with age, thats the advantage.
they wont improve anything...Leave a comment:
-
replace the small electrolytics.
TOPswitches like to go bang when the bootstrap/startup capacitor dries out....Leave a comment:
-
no difference - it works fine.
i dont see a problem with bipolar caps other than they are usually bigger...Leave a comment:
-
try this...
Leave a comment:
-
i used smd tantalums for that stuff....
Leave a comment:
-
i dont remember any 10uf, where are they on the board?...Leave a comment:
-
4A slow-blow aka time-delay.
NANO² package...Leave a comment:
-
recovery partition?
it wont save you from a head or surface failure!
thats what a backup drive is for....Leave a comment:
-
the chinese sell control modules on Ali for peanuts.
thats not the issue, the issue is if you get it wrong the mosfets or IGBT's are very expensive and all blow together.
because the module handles "dead time" between the pairs and when shit goes bad you get both oposing semiconductors turning on together and shorting the output....Leave a comment:
-
follow the signal, it may just be a bad transistor...Leave a comment:
-
the 723 is a simple chip, the datasheet shows example circuits
https://www.ti.com/product/LM723Leave a comment:
-
no because it needs to pulse to ground first...Leave a comment:
-
then you found the cause of the pc not starting.Leave a comment:
-
what i used to do,
2 drives, windowz and Linux.
use the windowz drive for stuff that wouldnt work in Linux BUT regularly try to run the software from Linux each time wine got updated.
it took about a year to not need the windowz drive
i'm still not sure what your device tree was, dvd drives are usually sr0 i think....Leave a comment:
-
https://linustechtips.com/topic/1562...-pg-value-huh/
it should go low initially and then jump up to 5v...Leave a comment:
-
trace it from the connector...Leave a comment:
-
if the rails are good then look at the supervisor chip that generates the PG signal
it may even be just cracked soldering linking one of the vertical sub-pcb's...Leave a comment:
-
NO.
the sine generator modules fail, they blow all your mosfets when they do.
this gives you an idea how they work
incidentally, they are not LF, they are high frequency pwm with the output then modulated to create a 50/60hz wave...Leave a comment:
-
you dont see stuff online about fixing newer / current motorolla stuff because they allegedly have a legal team supressing 3rd party info on the products.
thats why you wont find anything online about their DMR radio's.
they make far too much on service contracts to share any crumbs!Leave a comment:
No activity results to display
Leave a comment: